COPPERLAC is an air-dry lacquer, engineered to provide highly durable interior and exterior protection on color copper. The addition of UV and corrosion inhibitors to COPPERLAC assures endurance in harsh conditions such as arctic freezing, desert heat, beachfront salt air, and acid rain.

It has been discovered that even a blow torch cannot discolor a brass fitting protected by COPPERLAC.

• COPPERLAC air dries to touch in less than 5 minutes and dries hard to durable finish in about 2-3 hours.
• COPPERLAC should give satisfactory interior/exterior protection for at least ten years under normal conditions. Considerably longer life is expected.
• 12oz. Spray Can Available in Satin/Gloss Finish only.
• Coverage 15 to 20 Square-Ft

DIRECTIONS
Any dust collected on the copper sheet should be blown or wiped off with a dry cloth before COPPERLAC is applied.

COPPERLAC is applied in two full coats. First, apply a thin coat of COPPERLAC to your patina copper as a sealant. Allow three hours to cure between coats. Additional coats may be applied until desired thickness is achieved.


DRYING TIME
Air dries to the touch in less than 5 minutes. Air dries hard in two to three hours, depending on coating thickness, temperature, etc.


DISCLAIMER
The information in this document was obtained from sources, which we believe are reliable and correct, but does not purport to be inclusive and shall be used only as a guide. The information is provided without any representation or warranty expressed or implied regarding accuracy or correctness. The conditions or methods of handling, storage, use and disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, COPPERLAC and its employees do not assume responsibility and expressly disclaim liability for loss, damage, or expense arising out of, or in any way connected with, the handling, storage, use or disposal of the product.

Click Here for M.S.D.S.